If the wire feed unit of your RED by Lorch MIG-MAG welding machine causes increased wire abrasion, this is usually due to unsuitable feed rolls or incorrect settings.
Possible causes and solutions:
-
Wire feed rolls do not match the wire diameter
Solution: Use the correct wire feed rolls.
-
Incorrect pressure
Solution: Adjust the pressure correctly according to the operating instructions.
Note:
If the cause cannot be clearly identified or if there is a technical defect that needs to be repaired, please contact us via the contact form.
An overview of all error and warning messages for the RED MIG 210 Syn can be found in this article: Troubleshooting (RED MIG 210 Syn)
Detailed information on operation and further tips for handling RED devices can be found in the MIG 210 SYN operation manual