If the error code H06 is displayed on your RED by Lorch TIG 180 DC welding machine, this indicates a read or write error of the EEPROM memory. This is the internal memory of the device where important control information is stored.
Possible Cause for Code H06
Communication with EEPROM faulty
Solution
Turn the device off and then on again.
Perform a master reset.
Note:
If the error continues to occur after a restart, the device should not be used any further. Please contact us via the contact form, so that our service team can investigate the cause and carry out a repair.
An overview of all error and information messages for the RED TIG 180 DC can be found in this article: Troubleshooting (RED TIG 180 DC)
Detailed information on operation and further advice on handling your RED welding machine can be found in the TIG 180 DC operating manual