The error code E01 on the display of your RED by Lorch TIG 180 DC indicates an overheating in the TIG welding machine. The cause is usually excessive load or insufficient cooling. This can occur during both TIG welding and electrode welding. To prevent damage to the device, the welding operation is automatically interrupted.
Possible Causes and Solutions
Permissible duty cycle exceeded
Solution: Allow the device to cool down while idle.Airflow obstructed
Solution: Check the air intake and exhaust on the device.Fan defective
Solution: Turn the device off and on. The fan should start briefly; replace if necessary.Ambient temperature too high
Solution: Check the ambient temperature.
Note:
This error usually occurs if the device is heavily loaded or the cooling is blocked. If the error occurs repeatedly despite excluding these causes, please contact our service via the contact form.
An overview of all error and information messages for the RED TIG 180 DC can be found in this article: Troubleshooting (RED TIG 180 DC)
Detailed information on operation and further advice on handling your RED welding machine can be found in the user manual for the TIG 180 DC