If the tungsten electrode melts away during welding in TIG mode, this is usually due to incorrect settings or a faulty connection.
Possible causes and solutions:
-
Welding current set too high for the electrode diameter
Solution: Set the correct welding current according to the electrode diameter. You can find guidance on setting the correct parameters in our article: TIG Knowledge
-
TIG torch connected to the positive pole
Solution: Connect the TIG torch correctly to the negative pole.
Note:
If the cause cannot be clearly identified or if there is a technical defect that needs to be repaired, please contact us via the contact form.
An overview of all error and information messages can be found in the section Repair and Warranty
Detailed information on operation and further tips for handling RED devices can be found in the respective user manual for your welding machine